© 2014 Burnside Technology Ltd.
Page 8 of 24
Rev 1.1
Configuration of the terminal
The terminal may be configured using dial codes, commands entered via SMS or the USB interface.
Most commands entered via the USB are also accepted when the terminal is in Charge Only mode.
Some commands are only available via SMS and some SMS commands have both a configuration
code version and a more easy to remember text version.
See the “TX2_CommandsAndConfigCodesV_1_0” document for a convenient overview of the
options and codes.
Commands by DTMF dial codes (dialled on phone)
The command is prefixed with *8 then the command number then * followed by the parameter or
value then terminated by #
Example 1:
*83*2#
- sets the configuration register 3 with the value 2.
Example 2:
*83*2#*84*1#
- sets the configuration register 3 with the value 2 and register 4 with 1.
If a command is successful, two beeps are sounded on the handset. If there is an error, one long
beep is sounded. If there is an error, re-enter the correct code.
Command syntax for SMS or via USB
Command type:
Execute:
cmd Executes the command.
Read :
cmd? Returns the currently set value.
Write:
cmd=<...> Sets user-definable parameter value.
Commands may be concatenated by entering a semicolon delimiter for example “CFG3=2;FSUM”
Commands are not case sensitive.
To read multiple parameters, a suffix wild card may be used, for example: “CFG*?”.
When writing new values with the CFGn and PNUMSn commands, multiple parameters may be
entered by concatenation using a comma separator.
Example 1: CFG1=3,2=1,5=1
Example 2: PNUM0=+448700762666,11=+44712345678
Example 3: CFG1=3,2=1,5=1;PNUM0=+448700762666
Commands via USB interface (
install USB driver before connecting
):
The command line must start with AT!
Example 1: “
AT!cfg3=2<cr>
”
(<cr> carriage return/enter)
Example 2: “
AT!CFG3=2;Fsum<cr>
”
Note: Echo “E” and command response ”Q” (OK/ERROR) behave differently when the terminal is in
charge only mode or active.
In charge only mode, echo and response is turned on with ATE1Q0 or off with ATE0Q1, the default
is no response. This is to maintain compatibility with legacy flash programming software. When the
terminal is active, “E” and “Q” comply with normal ETSI standards.
Commands sent by SMS
The first 4 characters must be the terminal PIN (default is 1234). This is then followed by the
command(s).
