Omron XW2B Series, Руководство по подключению

Страница: 1 / 12

1
Position Control Terminal Block XW2B
Simplify Wiring between Motor Controls
and Omron’s Position Control PLC
Modules
H
Relays control signals between a servo
driver and the PLC position control module
or CQM1H PLC with pulse I/O capability
H
Connectors are wired with a single
screwdriver and no soldering is required
H
Dedicated cables connect terminal blocks to
position control modules
H
Requires 24 VDC for control signal use
H
Terminal block organizes wiring and saves
space; uses M3 screws
H
Mounts to DIN track or with screws for
panel mounting
NTLP: Don’t forget the standards.
Ordering Information
J
POSITION CONTROL TERMINAL BLOCKS
Appearance Applicable servo driver Applicable position control
module/CQM1H
Pulse I/O Board
Part number
U-series: R88D-UP
jjj
W-series: R88D-WT
jjj
C200H-NC112
C200HW-NC113
XW2B-20J6-1B
C200H-NC211
C200HW-NC213
C200HW-NC413
XW2B - 40J6-2B
CQM1H-PLB21 XW2B-20J6-3B
J
CABLES
Cables Between Servo Driver and Terminal Block
Appearance
Position control
terminal block
Applicable servo driver Cable length Part number
XW2B-20J6-1B,
XW2B 40J6 2B
R88D-UP
jjj
1 m (3.28 ft) XW2Z-100J - B1 ,
XW2B-40J6-2B
(See Note)
88 U
jjj
2 m (6.56 ft) XW2Z - 200J-B1
(See Note)
XW2B-20J6-3B
R88D-WT
jjjj
1 m (3.28 ft) XW2Z-100J-B4
XW2B 20J6 3B
88
jjjj
2 m (6.56 ft.) XW2Z-200J-B4
Note: Two cables will be required on the Servo Driver side if the XW2B-40J6-2B Terminal Block is used for two-axis control.