BURNiT PM 15kW, Инструкция по установке и обслуживанию

Страница: 9 / 56

9 - EN
Installer / Service Manual BURNiT Comfort PM/PM-B
3. Installing the pellet stove
3.1 General rules
Correct mounting and connection of the exhaust gases system is extremely important for the safety
use of the pellet stoves.
Any mistakes done during the installation are not covered by the MANUFACTURER.
It is obligatory the installation, the first start and the maintenance of the pellet stove to be
performed by an authorized installer/service BURNiT!
Recommendations BEFORE installing the pellet stove:

Check the minimum volume of the room where the pellet stove is to be installed (should be no
less than 40 m
3
);

Make sure there are holes for fresh air;

Follow all the norms/standards – technical, safety and constructional;

The proper functionality of the exhaust gases system (chimney reliability);

It is not permitted the installation of the pellet stove to be performed in bedrooms, bathrooms
as well as rooms which already had another heating unit installed without enough access of
fresh air (another stove, gas heater etc.)

There should not be any flammable substances in the room where the installation will be
done.
 The space around the pellet stove should be built with stones, cement or any other fireproof
material.
The minimum distance from flammable materials must be 200 mm. In case the floor is made of
flammable material (wood / parquet floor) it must be insulated with non-flammable one.
The steel pipes for exhaust gases must be mounted at distance minimum 1.5 m. from any flammable
materials. We recommend the pellet stove to be installed as closer as possible to the exhaust system
(chimney). The pipe system for the exhaust gases must be with maximum 3+1 T knees and maximum
3 m. from the horizontal flow with minimum deviation 3-5%. After the place for installation is defined
unpack the unit and check the closing of the front door.