Burndy PATMD430LWJAW, Инструкции по безопасной эксплуатации и техническому обслуживанию

Страница: 10 / 20

10
OPERATION INSTRUCTIONS
PATMDCUTLW Cutter Only:
1. Read and follow the PRE-OPERATION instructions
and Battery Charger Instruction Manual.
2. Ensure that jaws are fully open by depressing the
black retraction trigger.
3. Select and install the appropriate die set, if applicable,
for the connector and cable combination being
crimped. Insert a battery into the tool and disengage
the activation trigger lock only after all body parts are
clear of the jaw pinch point.
4. Position the tool properly on the connector making
certain that the die is aligned over the crimp area
indicators.
5. Insert the conductor into the connector, depress and
hold the green activation trigger to advance the tool.
6. Continue holding green activation trigger forward
until you hear the audible “pop” signifying the crimp
is complete.
7. Depress and hold the black retraction trigger until ram
fully retracts, or enough to move to next crimp location
if multiple crimps are required.
8. Continue crimping the connector until the proper
number of crimps have been completed. Work from
the center to the outer edges for splices and "H"
frame connectors, alternating sides if possible, for
the best compression connection. Remove tool from
connection.
PATMD-LW Crimpers Only:
Figure 1
1. Read and follow the PRE-OPERATION instructions
and Battery Charger Instruction Manual.
2. Ensure that the ram is fully retracted by depressing
the black retraction trigger.
3. Inspect the blades for wear or damage, especially on
the cutting edge. If cracks, chips or other damage is
found, discontinue use and replace blades according
to the blade replacement procedure.
4. If cutting less than 6 inches from the end of
uninsulated cable, it may be required to wrap tape
around the cable in the area to be cut to prevent the
strands from separating during cutting. If the cable is
not taped, this may prevent the tool from cutting or
retracting properly, and could damage the blades.
5. Insert a battery into the tool according to the PRE-
OPERATION instructions and dis-engage the
activation trigger lock only after all body parts are
clear of the jaw pinch point.
6. Insert cable into the tool.
7. Holding the tool perpendicular to the length of the
cable, depress the green activation trigger until the
cutting cycle is complete. If tape has been applied
(see step 4), be sure to cut directly on the tape.
8. Depress the black retraction trigger to retract the ram
and return the cutting blades to their original position.
Note: If the blades do not retract with the ram, a small
chip may be caught between the blades. In this case,
rest one side of the jaw on a stable surface and use a soft
hammer or rubber mallet and tap the back end of the jaw
until the blades release. See Figure 1 below.