become detached from the device and result in injury and / or damage to property
•
Do not allow the end of the spindle to contact the base of the hole in the abrasive
consumable.
Do not work in areas where there may be concealed electricity cables or gas or water
pipes. Use a suitable detector or ask your local utility service providers. Contact with
electricity cables can lead to fire or electric shock
Damaging a gas pipe can lead to an explosion. Penetration of a water pipe can lead to
property damage or to electric shock.
Operation Instructions
Note:Before using the tool, read the instruction book carefully.
The machine is intended for cutting, roughing and brushing metal and stone materials
without using water. For cutting metal, a special protection guard for cutting
(accessory) must be used.
1.
FITTING THE AUXILIARY HANDLE
Ensure the tool is switched off and unplugged at the mains
1) Identify the threaded hole on each side of the grinder head.
2) Screw the side handle firmly into one of them .
NOTE:
Always hold your angle grinder firmly with both hands when operating.
2. ADJUSTING THE GUARD
WARNING
: Switch off the grinder and disconnect it from the main power
1) Loosen the clamping belt by unscrewing the hexagon screw with the supplied
hexagon key.
2) Position the lug on the inside of the central guard in the vertical slot in the spindle
cover and press the guard onto the spindle cover.
3) Twist the guard to the appropriate position , where it will deflect hot sparks away
from the operator •
Retighten the screw to lock the guard in position
WARNING : for cutting metal, always work with the wheel guard for cutting(no
supplied).
Содержание M3101A
Страница 1: ...User Manual Angle Grinder M3101A...
