For best tool control, material removal and minimum overloading, maintain an angle
between the disc and work surface of approximately 15°-30° when grinding.
Use caution when working into corners as contact with the intersecting surface may
cause the grinder to jump or twist.
d)Use special care when working corners, sharp edges etc. Avoid bouncing and
snagging the accessory.
Corners, sharp edges or bouncing have a tendency to
snag the rotating accessory and cause loss of control or kickback.
e)
Do not attach a saw chain woodcarving blade or toothed saw blade. Such blades
create frequent kickback and loss of control
ADDITIONAL SAFETY INSTRUCTIONS FOR
GRINDING AND CUTTING-OFF OPERATION
Safety Warnings Specific for Grinding and Abrasive Cutting-Off Operations
a)
Use only wheel types that are recommended for your power tool and the specific
guard designed for the selected wheel. Wheels for which the power tool was not
designed cannot be adequately guarded and are unsafe.
b)
The guard must be securely attached to the power tool and positioned for
maximum safety, so the least amount of wheel is exposed towards the operator. The
guard helps to protect operator from broken wheel fragments and accidental contact
with wheel.
c) Wheels must be used only for recommended applications. For example: do
not grind with the side of cut-off wheel.
Abrasive cut-off wheels are intended for
peripheral grinding, side forces applied to these wheels may cause them to shatter.
d) Always use undamaged wheel flanges that are of correct size and shape for
your selected wheel.
Proper wheel flanges support the wheel thus reducing the
possibility of wheel breakage. Flanges for cut-off wheels may be different from
grinding wheel flanges.
e) Do not use worn down wheels from larger power tools.
Wheel intended for
larger power tool is not suitable for the higher speed of a smaller tool and may burst.
Additional Safety Warnings Specific for Abrasive Cutting-Off Operations
ADDITIONAL SAFETY INSTRUCTIONS FOR CUTTING-OFF OPERATIONS
a)Do not “jam” the cut-off wheel or apply excessive pressure. Do not attempt
to make an excessive depth of cut.
Overstressing the wheel increases the loading
and susceptibility to twisting or binding of the wheel in the cut and the possibility of
kickback or wheel breakage
b)Do not position your body in line with and behind the rotating wheel. When
the wheel,
at the point of operation, is moving away from your body, the possible
kickback may propel the spinning wheel and the power tool directly at you.
c)
When wheel is binding or when interrupting a cut for any reason, switch off the
power tool and hold the power tool motionless until the wheel comes to a complete
stop. Never attempt to remove the cut-off wheel from the cut while the whee
丨
is in
motion otherwise kickback may occur. Investigate and take corrective action to
Содержание M3101A
Страница 1: ...User Manual Angle Grinder M3101A...
