eliminate the cause of wheel binding
d)
Do not restart the cutting operation in the workpiece. Let the wheel reach full speed
and carefully re-enter the cut. The wheel may bind, walk up or kickback if the power
tool is restarted in the workpiece
e)Support panels or any oversized workpiece to minimize the risk of wheel
pinching and kickback.
Large workpieces tend to sag under their own
weight.Supports must be placed under the workpiece near the line of cut and near the
edge of the workpiece on both sides of the wheel
f)Use extra caution when making a “pocket cut'* into existing walls or other
blind areas.
The protruding wheel may cut gas or water pipes, electrical wiring or
objects that can cause kickback.
ADDITIONAL SAFETY INSTRUCTIONS FOR SANDING
OPERATIONS
Safety Warnings Specific for Sanding Operations
a) Do not use excessively oversized sanding disc paper. Follow manufacturer’s
recommendations, when selecting sanding paper. Larger sanding paper
extending beyond the sanding pad presents a laceration hazard and may cause
snagging, tearing of the disc or kickback
Additional safety rules for angle grinders
•
DANGER OF ELECTRIC SHOCK! Do not operate the device if the mains lead
or mains plug is damaged.
•
DANGER OF ELECTRIC SHOCK! Do not touch the mains lead if it becomes
damaged or cut through while you are using the device. Pull the plug out of the mains
socket immediately and have the device repaired by a suitably qualified person or at
your service centre.
•
DANGER OF ELECTRIC SHOCK! Do not operate the device if it is damp and do
not use it in a damp environment.
•
DANGER OF ELECTRIC SHOCK! If you use the device outdoors, always connect it
through a residual current device with a maximum trip current of 30 mA. If using an
extension lead, always use one that is approved for outdoor use.
Do not suspend or carry the device by the mains lead. Always work with the mains
lead leading away from the rear of the device. Otherwise the device could be
damaged
•
Grinding discs must be carefully kept and handled in accordance with the
manufacturer's instructions. Otherwise they could be damaged.
•
Make sure that abrasive consumables and tools are attached in accordance with
the manufacturer's instructions and advice. Otherwise they could become detached
from the device and result in injury and / or damage to property.
Ensure that any spacers supplied and required for the use of certain abrasive
consumables and tools are installed
•
Do not use separate reducing bushes or adapters in order to make grinding discs
with a larger bore fit.
When using abrasive consumables and tools with a threaded insert make sure that
the tread is long enough for the spindle length. Otherwise the grinding discs could
Содержание M3101A
Страница 1: ...User Manual Angle Grinder M3101A...
