10.
To light the fire, ensure the left hand (Black) control knob is turned fully clockwise to OFF. Press the
red knob and turn slowly anticlockwise to the ignition position. A click will be heard and the pilot
(under right side of fuel bed) should light. If it does not repeat the operation a few times. Continue
to hold red knob for 15 – 20 seconds to establish the pilot and then release. If pilot fails to establish,
turn off, wait 1 minute then repeat lighting procedure. Rotate the control knob to high flame to
light then back to the desired flame position. If no gas comes through rotate the black knob
(thermostat) to a hotter room setting and the fire will light.
Control the fire by a combination of thermostat and / or flame setting to suit your mode of use
To turn the fire off, rotate the red knob fully clockwise.
NOTES
The first time that the appliance is used, there will be some odour produced due to the newness of
the materials. It is recommended that the unit is fired at maximum setting for several hours and the
room is kept ventilated during this period. It is usual for Flueless appliances to produce an initial
odour after start up.
If the pilot flame should ever extinguish of its own accord, ventilate the room and allow a minimum
of 5 minutes before relighting.
Never attempt to relight the unit if there is a smell of gas.
If the unit continues to extinguish after a period of use, do not use it and seek the advice of your
installer.
TURNING OFF PROCEDURE
To extinguish the pilot, turn the valve to the OFF position. Note that if the gas supply fails at any
time, the pilot will extinguish. Carry out the lighting procedure to re-ignite.
Cleaning the fuel effect
Switch the appliance OFF and allow to cool before commencing. The fuels can be accessed by
opening the hinged door on the appliance which is secured by a 10mm nut. On no account should
the appliance be operated whilst the door is open.
Do not lay the coals in any way other than that shown in the Installation and Servicing Instructions.
•
Do not use the fire with broken coals.
•
Do not add any additional fuel elements to the fire.
•
Do not use similar looking parts from other appliances, use only genuine spare parts.
•
Do not use the appliance for burning waste.
•
The fire must not be run with its door open or with cracked, incorrectly fitted or missing glass.
•
On no account must air inlets under the stove or outlet grills (see diagram) be obstructed
GENERAL
To qualify for your free second year guarantee, you must fully complete and return the separate
Guarantee Card. There are sections that your fitter must complete whilst fitting the fire. If the fully
completed Guarantee Card is not returned within 7 days of fitting, the appliance is just covered by
the standard 12-month guarantee.
As with all gas appliances, this fire MUST be serviced at least every 12 months, preferably at the
start of the heating season. The second year guarantee is conditional on this service-taking place; a
dated service receipt is proof of this. A qualified service engineer must carry out servicing.
Due to our policy of continual improvement and development the exact accuracy of descriptions and illustrations can
not be guaranteed.
Burley Appliances are the only company to bench run and thoroughly test every single Flueless gas fire it produces.
Burley is in the unique position of knowing that every appliance leaves the factory in perfect working order.
