Installing Seat Pads
Match hook and loop fastening strips on trailer seat to back
side of seat pad.
Installing Shoulder Harness Pads
(d’lite, Solo)
Insert shoulder straps through loops on shoulder harness
pads, with straps oriented so that FLAT sides of strap buckles
face each other.
FIGURE 7
Using Seat Harness
One Passenger:
Note:
In two-passenger trailers, use inner shoulder straps and
crotch strap.
1. Place child in center of seat.
2. Snap shoulder straps into Y-buckle, with buckle positioned
at child’s sternum. Adjust straps so that child cannot move
too far forward in seat.
3. Fasten and adjust lap belt snugly.
FIGURE 8
Two passengers:
Note:
For two children, use both shoulder harnesses and two
outer crotch straps.
1. Seat first child on one side of seat.
2. Snap shoulder straps into Y-buckle, with buckle positioned
at child’s sternum. Adjust straps so that child cannot move
too far forward in seat.
3. Repeat for second child.
4. Fasten and adjust lap belt snugly. To remove children,
release lap belt and harness buckles.
FIGURE 9
Note:
For taller children, the seat harness can be adjusted by
moving the buckles on the shoulder strap webbing into
the helmet pocket area, above the horizontal elastic.
FIGURE 9
8
B U R L E Y D ’ L I T E , E N C O R E A N D S O L O O W N E R ’ S I N S T R U C T I O N A N D S A F E T Y M A N U A L
ALWAYS SECURE CHILDREN WITH HARNESS AND LAP BELT
BEFORE USE. ONLY USE THIS SEAT IF YOUR CHILD IS CAPABLE OF
SITTING UPRIGHT ALONE. FAILURE TO DO SO COULD RESULT IN
AN ACCIDENT AND SERIOUS INJURY OR DEATH.
WARNING
IMPORTANT
SINGLE PASSENGER MUST BE SEATED IN CENTER POSITION.
FIGURE 8
FIGURE 7
Flat face of buckles
face each other
Harness Pads
Lap Belt
Lap Belt
Harness
Pads
Harness
Pads
IMPORTANT
DO NOT SLIDE SHOULDER STRAP ASSEMBLIES ABOVE
WEBBING STOPS.
