TSE HOME 4001
English |
11
Remark
The basic size of the cylinder is 30 mm for each side. When delivered,
the cylinder is completely pushed together (smallest possible cylinder length).
Before you embed the cylinder into the door, you need to adjust the exterior
knob to door thickness.
To install the cylinder, proceed as follows:
1
Take a rough measurement of the door thickness (incl. fittings)
2
Pull the inner knob away from the shaft, move the outer knob over the
detent system (spacing 2.85 mm) to the required dimension.
Schematic representation of
adjustment of the outer knob
3
the TSE cylinder outside in through the mortise lock into
the door and then tighten the fixing screw.
4
Shift the outer knob along the shaft until the required dimension is
attained. Please make sure that the distance between the rotary knob
and the door mounting is at least 1 mm. Then fix the knob using the
hex key.
5
Shift the interior knob into the required position on the shaft and fix
it with a distance of at least 1 mm from the strike plate by using the
hex bolt.
Make sure that the interior knob is shifted on the shaft in a way that
the fixing screw (inside the knob) faces the shaft with the little holes
at the side.
6
The function test must be made while the door is open.
Replacing the knob batteries (exterior)
Attention: When replacing the batteries, make sure that no
precipitations or humidity penetrate the batteries, as no water can
escape when the compartment has been closed.
1
Loosen the hex screw on the cover and remove it.
The fixing
screw may be loosened only so far that the cover can be
opened. It must never be unscrewed from the cover.
2
Pull the silicone cover out and replace the batteries.
Check the correct polarity of the cells.
3
Place the silicone cover on the batteries, close the cover
and tighten the fixing screw.
