BUNNING Lowlander MK4, Инструкция по эксплуатации

Страница: 20 / 138

LOWLANDER MK4 MANURE SPREADER – INSTRUCTION & SPARES MANUAL
Page
15
1.9 OPERATING INSTRUCTIONS FOR HORIZONTAL BEATERS
General use
The horizontal beater with spinner discs is designed primarily for wider spread patterns and lower
application rates for product such as chicken and turkey manure, however long straw based
materials can be spread effectively. It must be expected that application rates maybe slower than
a vertical auger spreader.
Adjustments for spread patterns
The position of the lower section of rear canopy and the angle of the blades on the discs will affect
the spread pattern and width.
Select a hole position that places the rubber strip over the middle of the discs for a lighter
application rates and wider widths. Adjust the hole position to move the rubber strip rearwards
for higher application rates e.g. for straw based materials. Excessive rearward adjustment will
cause the material to miss the discs and hit the ground without being spread.
Each spinning disc is supplied with 2 blades on and the others loose; it has been proven that many
materials are spread more effectively with just 2 blades per disc.
1 To increase the width of the spread pattern adjust the angle of blades forward on the disc.
2 If the spread pattern is light immediately behind the machine adjust the angle of the blades
back.
3 With 4 blades fitted it is possible to achieve an even spread by adjusting the blades, as
opposing pairs. i.e. Blade 1 and 3 in position 3 and blade 2 and 4 in position 1.
4 When adjusting angle use the 2nd set of holes on the blade to keep the tip of the blade on
the edge of the disc
Change angle of lower
canopy here.
Rubber strip pointing
at the centre of the
spinning discs.