Page 36
Procedure to set funnel detect:
1. Press and hold the upper right hidden switch until
display reads
UNITS
. Release the switch. Continue
to press and release switch until display reads
FUNNEL DETECT
.
2.
NO
or
YES
should be flashing to indicate the cur-
rent setting.
4. Select
YES
to prevent brewing if a Smart Funnel is
not correctly situated in the rails. If this function
is activated and a brew cycle is attempted with the
funnel not properly situated, the display will read,
FUNNEL NOT IN PLACE
, until one is in place.
5. Select
NO
to allow brewing without a Smart Fun-
nel in place. This is selected when brewing with a
funnel other than a Smart Funnel (a regular brew
funnel).
6. When finished, press and release
DONE
. This will
retain the changes, exit this function screen and
advance to the next. Another alternative is to press
either ON/OFF switch located on the front switch
panel to exit the
FUNNEL DETECT
and return to
the
MAIN SCREEN.
P2721
5. When finished, press
NEXT
to advance counter
screens until the display reads
BREW COUN-
TERS.
Press and release
NO
to advance to the
next function screen, or press and release either
ON/OFF switch on the front switch panel to exit
the
BREW COUNTERS
function and return to the
MAIN SCREEN.
FUNNEL DETECT (optional)
This function allows the operator to prevent the
start of a brew cycle if a Smart Funnel is not positioned
correctly in the funnel rails.
P2721
Procedures to set server detect:
1. Press and hold the upper right hidden switch until
display reads
UNITS
. Release the switch. Continue
to press and release switch until display reads
SERVER DETECT
.
2. The
NO
or
YES
flashes to indicate the current
selection.
3. Select
YES
to prevent brewing if the Soft Heat
server is not correctly positioned on the brewer
beneath the funnel.
NOTE:
If
YES
is selected and a brew cycle is attempted
with a server not properly placed, the display will read
SERVER NOT IN PLACE
.
4. Select
NO
to allow brewing without a Soft Heat
server in place. This is selected when brewing into
a container other than a Soft Heat Server.
5. When finished, press and release
DONE
. This will
save the new setting, exit the function screen and
advance to
SERVICE TOOLS
. Another alternative is
to press either ON/OFF switch located on the front
switch panel to exit the
SERVER DETECT
function
and return to the
MAIN SCREEN.
SERVER DETECT
This function allows the operator to prevent the start
of a brew cycle if a Soft Heat server is not positioned
correctly on the brewer.
BREW COUNTERS (cont.)
FUNNEL DETECT ?
NO
DONE
YES
SEVER DETECT ?
NO
DONE
YES
PROGRAMMING THE BREWER (cont.)
29877-3 062005
