Page 23
27 for description of %BYPASS function).
13. Using (-) and (+), set the amount of bypass
water (percentage) to be dispensed around the
grounds.
14. When finished, press the other batch size and repeat
step #13.
15. When finished setting both batch sizes, press and
release DONE. The display should read 2 BATCHES
DONE?
16. If both batch sizes are not correct press and release
NO to return to the %BYPASS function and repeat
steps #13, 14 and 15.
17. If both batch sizes are correct, press YES. This will
advance to the SET PULSE BREW function (Refer
to page 28 for description of SET PULSE BREW
function.
18. To SET PULSE BREW press YES and proceed with
the setup instructions for SETTING PULSE BREW,
on page 29.
19. To skip setting the PULSE BREW and to use the
FACTORY DEFAULTS, press NO to proceed to the
DRIP TIMES function.
20. The display should now read DRIP TIME, along with
either the word OFF or a time showing. A batch light
will also be blinking.
21. Using (-) and (+), set the amount of time from when
the brew spray ends to when the funnel is emptied
of hot liquid.
22. When finished, press the other batch size and repeat
step #21.
23. When finished setting both batch sizes, press and
release DONE. The display should read 2 BATCHES
DONE?
24 Press and release YES. The screen should show the
name of the coffee being programmed (modified)
along with SETUP COMPLETE.
25. After a 5 second delay, the display will advance to
the next coffee name in the brewer’s memory. If
no other coffee names are present, the display will
read THAT WAS THE LAST RECIPE, and advance
to the SET TEMP screen.
PROGRAMMING THE BREWER (cont.)
PROGRAMMING FUNCTIONS - LEVEL 2 (cont.)
38112.1 101005
