5
CLEANING
EXTERIOR SURFACES
The use of a damp cloth rinsed in any mild, nonabrasive, liquid detergent is recommended for cleaning all
surfaces on Bunn-O-Matic equipment. Care should be taken not to scratch the hopper or windows with any
abrasive material. Regular cleaning will keep your grinder looking new for years.
COFFEE GRINDING
1. Set the Rotary Batch Selector Switch for the desired batch size and visually inspect the hopper for an ample
supply of whole bean coffee.
2. Carafe brewing: Place a paper filter into the brew funnel. Insert the funnel into the rails and push until it
stops.
3. French Press brewing: Place French Press on grinder base and push towards rear until it stops.
4. Momentarily press Off/On/Start switch to the “START” lower position and release. The grinding action will
stop automatically after the preset amount of ground coffee is dispensed into the funnel.
5. Remove the funnel from the grinder and level the bed of grounds by gently shaking.
6. The loaded funnel is now ready for use in any commercial drip coffee brewer according to the manufacturer’s
instructions.
36783.1 042211
GRIND CHAMBER
1. WARNING - Unplug grinder before cleaning.
2. Empty all beans from the hopper.
3. Plug-in the grinder, place funnel with filter into funnel rails. Press the Off/On/Start switch to the “START”
lower position and release. Run a few grind cycles until all the coffee in the grind chamber is dispensed and
disconnect grinder from the power source.
4. Remove the funnel with filter and carefully tip the grinder over on it’s back.
5. Clean the grind chamber and all parts with a dry non metallic bristle brush and wipe with a dry clean cloth.
PREVENTIVE MAINTENANCE
Bunn-O-Matic
®
Corporation recommends that preventive maintenance be performed at regular intervals. Maintenance
should be performed by a qualified service technician. For Technical Service, contact Bunn-O-Matic
®
Corporation at
1-800-286-6070.
NOTE: Replacement parts or service caused by failure to perform required maintenance is not covered by warranty.
6-Month
Weekly Cleaning plus replace the dechaffer assembly.
1-Year
1. On grinders with slide plates check the slide plates and clean.
2. Inspect and clean/replace burrs and grind chamber if necessary.
3. Adjust the burrs and grind time to your specifications for particulate size and throw weight.
