Page 23
Installation:
1. Connect motor and sensor harness to the new
motor assembly.
2. Connect brewer to power source. Press "OPEN/
CLOSE" button to open pod door. (or use the
"TEST OUTPUTS" to move it to "LOAD POSITION").
3. Unplug brewer.
4. Verify motor assembly is in the OPEN/LOAD po-
sition. FIG 22-1.
5. Install motor assembly and snug mounting nuts.
6. Verify door assembly is open. Tighten allen screws.
NOTE: DO NOT TIGHTEN ALLEN SCREWS UNTIL
MOTOR BRACKET IS SECURE AGAINST EJEC-
TOR WALL.
7. Install "puck" into pod holder. FIG 22-2.
8. Remove thumbscrew and sprayhead. If neces-
sary, use alignment tool to push sprayhead out.
NOTE: It will be easier to get your hand inside if
you use the “TEST INDEX MOTOR” to move pod
holder all the way to the back position.
9. Power up brewer and Press "OPEN/CLOSE" but-
ton to close pod door.
10. Slightly loosen 2 nuts securing motor mounting
bracket to ejector wall. FIG 22-3.
11. Insert alignment tool. FIG 22-4. Rotate motor
assembly (FIG 22-5) with adjustable wrench un-
til alignment tool slips into puck. Tighten nuts.
NOTE:
Alignment tool should drop into align-
ment puck with little to no force. If force is re-
quired, repeat step 11.
12. Remove tools. Cycle door open/closed a few
times and test for proper operation. If any error
codes are displayed, repeat the alignment proce-
dure.
13. Install sprayhead and thumbscrew.
EJECTOR ASSEMBLY
FIG 22-1 Motor in open position.
IMPROPER ALIGNMENT COULD CAUSE
LEAKAGE OF HOT WATER AT THE SPRAYHEAD SEAL.
:
FIG 22-5 Rotate motor assembly.
FIG 22-2 Install "puck".
FIG 22-3 Slightly loosen both nuts.
FIG 22-4 Insert alignment tool.
41169 120711
Sensor is "un-blocked"
