Page 9
For technical questions, please call 1-800-444-3353.
Item 69643
maintenance and Servicing
procedures not specifically explained in this manual must
be performed only by a qualified technician.
tO pRevent SeRiOuS injuRY FROm tOOl FailuRe:
Do not use damaged equipment. if abnormal noise or vibration
occurs, have the problem corrected before further use.
Cleaning, maintenance, and lubrication
1.
BeFORe eaCh uSe,
inspect the general
condition of the tool. Check for:
• leaking, swollen, or cracked battery pack,
• loose hardware,
• misalignment or binding of parts,
• cracked or broken parts, and
• any other condition that may
affect its safe operation.
2.
aFteR uSe,
wipe external surfaces
of the tool with clean cloth.
3. NiCd BATTERY MUST BE RECYCLED
OR DISPOSED OF PROPERLY. Do not
short, incinerate or open battery.
troubleshooting
problem
possible Causes
likely Solutions
Light won’t
turn on.
1. Power is not on.
2. Cable connection is loose.
3. LUX control is set
too close to .
4. Motion sensor not
detecting movement.
5. Battery pack not fully charged.
1. Check that Power Switch is set to ON or AUTO.
2. Plug in firmly at back of Battery Housing.
3. Turn LUX knob towards .
4. Adjust angle and direction of Motion Detector Head.
5. Keep solar panel clean. Allow to charge in full
sunlight for 3 days with the Power Switch OFF.
Light turns on
during day.
LUX control is set too close to . Turn knob towards .
Light flashes
on and off with
clicking sounds.
Low battery.
With Switch set to “OFF”, allow to charge in full
sunlight for 3 days before further use.
Light stays
“ON”.
1. Duration time setting too long.
2. Frequent changes in heat being
detected.
3. Power Switch set to ON.
1. Turn TIME knob counterclockwise to
reduce the time the light stays on.
2. Check sensing area for possible heat sources such
as air vents, vehicles or objects in wind. Reposition
the Motion Detector Head if needed, or turn SENS
Knob counterclockwise to lower sensitivity.
3. Turn Power Switch to AUTO.
Light turns ON
and OFF.
1. Changes in heat are being
detected from a fixed heat
source or moving object.
2. Sudden temperature change
due to storms or high winds.
1. Check sensing area for possible heat sources
such as air vents, vehicles or objects in wind.
Reposition the Motion Detector Head.
2. Turn Power Switch “OFF” until storm passes.
Mount in a sheltered location.
Follow all safety precautions whenever diagnosing or servicing the tool.
Disconnect Battery pack and Charger power supply before service.
Sa
Fet
Y
Ope
R
ati
O
n
m
aintenan
C
e
Setup
