Page 3
For technical questions, please call 1-888-866-5797.
Item 61565
8. WARNING: The brass components of this product
contain lead, a chemical known to the State
of California to cause cancer and birth defects
or other reproductive harm. (California Health
& Safety Code § 25249.5,
et seq.
)
9. The warnings, cautions, and instructions discussed
in this instruction manual cannot cover all possible
conditions and situations that may occur. It must
be understood by the operator that common sense
and caution are factors which cannot be built into
this product, but must be supplied by the operator.
10. The Safe is not fireproof.
NOTE:
Harbor Freight Tools is not responsible
for the loss of any property stored within this safe
due to theft, fire, or any other circumstance.
Installation Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this document
including all text under subheadings therein before set up or use of this product.
This safe may be used as a roll-about with the included casters, or may
be bolted to the wall for more permanent installation.
Wheel Assembly:
1. Place the Safe on its side for easy
access to the bottom of the Safe.
2. Assemble each wheel using the included wheel axles.
3. Secure each wheel in place using Cotter Pin.
Wheel
Cotter
Pin
Wheel
Axle
4. The Safe may be bolted to a wall or
a floor to deter theft and prevent tipping.
There are mounting holes in the back wall and
bottom of the safe. See Figure A below.
Mounting
Holes
Figure A: Rear Mounting Hole Locations
5. Use Anchor Bolts, or seek a bonded professional
for installation of the Safe into cement.
Note:
For floor or wall mounting, use bolts of a suitable
size (not included) to bolt into wall studs or floor joists.
6. Using the back of or bottom of the Safe as a
template, mark the location of the mounting holes on
the concrete surface using a pencil or other marker.
7. Move the Safe aside, and drill four suitable pilot
holes in the mounting surface. Make certain that
the drilling path is clear and free of obstacles such
as wires, cables and electrical lines. Drill holes
should be the diameter of the Anchor Bolt sleeves.
8. Insert the Anchor Bolts into each drilled hole and
tap Bolts into concrete. Remove washer and nut
from each bolt. The Safe now has to be lifted into
position to fit over the four anchor bolts. Because of
the heavy weight of the Safe, this task should only
be done by several capable workmen. With the
Safe in position, add washers and nuts to Anchor
Bolts. By tightening the nuts in place, the sleeve
around each bolt will expand, and secure each bolt
into the concrete to secure the Safe in place.
