splash-and-splashcenter-manual-en
Page 8 / 19
Splash-Center:
Beside the spray chamber there are 4 vertical treatment basins with each having approx. 10 l (16l
XL) content. The first tank from left is the first (static) rinsing zone. Then follows the combined
static/spray rinse with two horizontally attached nozzle tubes, which are activated by single magnetic
valve and foot switch. This rinse has a floor drain and an adjustable overflow.
The third basin serves for developing positive coated plates or for stripping negative laminate. The
liquid herein is rolled over by a small centrifugal pump when the machine is switched on. Note! This
pump may not run dry! Therefore this bath must be always filled at least with water. In this basin is
a lifting device which enables to take out pcbs out of the tank without having contact to the caustic
solution. A sifter prevents parts from getting into the pump.
The drain valves for the etching agent and the rinse water are well accessible below the respective
containers.
In the rinsing zones are short pipes in the floor drains. These are to hold back possible slugde sedi-
ments when emptying. If you want to completely empty the tanks, just pull up the pipes with a plier.
Splash-Center: The machine is supplied with a safety catch pan. This tub is so dimensioned that it
can take up the entire liquid in the accident.
Bungard Elektronik GmbH & Co. KG, Rilkestraße 1, 51570 Windeck – Germany
Tel.: +49 (0) 2292/9 28 28 - 0, Fax: +49 (0) 2292/9 28 28 - 29, E-mail: [email protected]
