splash-and-splashcenter-manual-en
Page 6 / 19
Used up etching agent is special refuse. It must be handed over to certified disposal enterprises under in-
dication of the waste key number. Pay attention to the refuse laws and regulations of your country. We are
not authorized to redemption.
Prior to operating the machine, be informed on all applying environmental protection legislation of your
country. Used etching liquid contains copper and must be treated as special waste. In most countries, this
applies also for the rinse water. We recommend that you collect dirty rinse water and use it to set up fresh
etching liquid or to compensate evaporations losses. In accordance to anti pollution laws, the final clean-
ing of the boards normally requires a cascade rinsing unit, or further wet process steps, like chem. tinning
or resist stripping. Any attempt to neutralize the etchant or the rinse water is NOT recommendable to other
than approved chemists.
If you do not have an appropriate water purification for the rinse water in your facility, we recommend
our waste water processing facility
Ionex
for this task.
Short instructions
Upon reception examine the machine for any apparent
damage, and if so inform your shipping agent and us
immediately.
Please read the manual carefully and follow the safety
instructions.
Transport the machine to its place by lifting it up at two
legs on each side.
The floor must be level. Underlay the legs if necessary.
Make sure the drain valves are closed.
Splash Center: Connect the combined
spray/static rinse inlet to your water supply
and the drain to the sewer system. The inlet
has a ¾ inch screw and the outlet a 20 mm
drain spout. Choose the appropriate hoses
and clamps. Please understand that we can-
not supply these hoses due to different con-
nection standards worldwide.
Mount the sieve into the spray chamber, if ne-
cessary.
For a first test of the machine fill the spray
chamber up to the sieve with water. Fill the
rinse and treatment tank, each with about 10
liters of water.
Connect the machine to the mains (we as-
sume that your electric system is protected by
RCD according to your local regulations).
Turn the main switch and the switch for the
heater. In operation, the switch lights and the
heating element changes to an orange-red
color.
Bungard Elektronik GmbH & Co. KG, Rilkestraße 1, 51570 Windeck – Germany
Tel.: +49 (0) 2292/9 28 28 - 0, Fax: +49 (0) 2292/9 28 28 - 29, E-mail: [email protected]
