13
Preparing the RFI intake for installation:
1. Snap the RFI Intake tube into the
intake enclosure, this may take a
bit of pressure. Make sure to insert
the tube from outside to in with
the snaps in front.
2. Carefully remove the MAF
sensor from the stock intake
enclosure, use the T-15 torx bit
(included with the kit) with a bit
driver to remove the torx head
screws holding the MAF in place.
Take very good care of the MAF
sensor while transferring it over
to the Bully Dog RFI.
3. Insert the MAF sensor into the MAF sensor mount on the RFI tube. Use the black oxide
screws included with the kit to secure the MAF sensor to the RFI tube.
RFI Prep
