OD0821 ROCKfrog
© 2 0 2 1
K U R T B E I E R & K A T I Q U I N G E R
B
C
A
Put drive systems into operation successively,
don`t
operate several systems simultaneous.
Otherwise the remote control cannot be assigned clearly by control/motor.
1. Press pairing buttons A at receiver 2 x until the LED indicates. The pairing process is active for about
10 seconds.
2. Press simultaneous button
B
and
C
at the transmitter until the green LED at the receiver vanishes.
This confirmes a successful pairing process.
Note: For the pairing prozess the distance between transmitter and receiver should be less than 2 metres.
The programming is completed, the transmitter is now ready for operation. If the motor doesn´t start while
pressing, release the button and press again. If necessary retry the process.
LED
Back
Back
1. Put the back straight and retract
the foot flap. Then tilt the element
forwards over the skids.
Use a suitable base to avoid damage
to the cover or your floor.
2. Extend the footrest into horizontal
position.
3. Open the zip underneath the
element. The receiver is located
inside of the element.
Motorised seat adjustment - Programming of transmitter and receiver
Delivery condition: already synchronised
November 2021
Wireless remote control:
Warning of magnetic field.
Brief instruction, Pairing-Method:
Should a new start-up of remote control be necessary the wireless communication with the control/motor
must be established. Proceed as follows:
Footrest
retracted
Footrest extended
Receiver
Transmitter