OPERATING INSTRUCTIONS
If you are operating your RS302 from an existing alarm’s second channel output
NOTE: You may have to disarm your alarm before starting the car.
1. Before turning off the vehicle, always remember to set the heater or air conditioning for proper temperature desired.
2. To start your vehicle, activate the second channel output from your vehicle’s alarm transmitter. The parking lights
should flash once confirming that the starter received the signal.
3. In approximately two seconds the starter should attempt to start the vehicle. When the vehicle starts, the computer
will check the entire electrical system and then turn on the parking lights. The parking lights will remain on
until the engine shuts off. If the vehicle fails to start on the first try, the starter will automatically attempt
to start the vehicle three more times.
4. To shut off the remote starter, activate the output one more time or step on the brake pedal.
If you are operating your RS302 from a factory keyless entry system:
1. Before turning off the vehicle, always remember to set the heater or air conditioning for proper temperature desired.
2. To start your vehicle, press the LOCK button three consecutive times within three seconds. The parking lights will
flash each time you press the LOCK button confirming that the car starter received the signal.
3. In approximately two seconds the starter should attempt to start the vehicle. When the vehicle starts, the computer
will check the entire electrical system and then turn on the parking lights. The parking lights will remain on
until the engine shuts off. If the vehicle fails to start on the first try, the starter will automatically attempt
to start the vehicle three more times.
4. To shut off the remote starter, activate the output one more time or step on the brake pedal.
IMPORTANT: Before pressing the brake pedal and attempting to drive the vehicle, turn the ignition key switch to the
ON position.
NOTE: Some vehicles with automatic transmissions will start while in drive. Test each vehicle by putting the transmission
in drive, stay in the vehicle and make sure you do not press the brake pedal. Now try to remotely activate the car
starter. If the car starts, refer to the Neutral Safety Instructions.
8