HOW TO USE YOUR REMOTE TRANSMITTER
10
“Type C” Reverse Polarity (5-pin harness)
NOTE: You will need to cut factory wiring to make an end to
end connection, see “Making Connections” on pages 3-4.
POWER
DOOR
LOCK
MOTOR
LOCK
UNLOCK
GREEN/BLACK Unlock
GREEN/WHITE Unlock
RED/BLACK
BLUE/BLACK Lock
BLUE/WHITE Lock
KEYLESS MODULE
+12V
Constant
FUSE
NOTE: Connect the RED WITH BLACK STRIPE wire
to +12V constant power fused at 30 amps.
BULLDOG
Start
Arm
Disarm
Trunk
Stop
1. Starting the Vehicle with the Remote Transmitter
Press and release button #1 (start). The parking
lights will flash once, confirming the car
starter received the signal. The car will then
start and the parking lights will turn on and
remain on while the vehicle is running. To
shut off the engine before the preset time,
press button #4 (stop) or press the brake
pedal or when the hood is opened. NOTE: If
your car does not start on the first crank it
will automatically attempt to start up to 2
more times. (only in tachless mode) In tachless
mode, parking lights will wait approximately
10 seconds before turning on.
BUTTON #1
Remote starts your vehicle
from up to a quarter mile away.
BUTTON #2
Arm locks and disarm unlocks
your power door locks.
BUTTON #3
Pops your trunk.
BUTTON #4
Turns off your remote starter and helps
you locate your car (when system is
armed).
2. Pit Stop: Exiting the Car with the Engine Running
Make sure the transmission is in park and press button #1 (start) before turning the ignition switch
off. (The engine will remain running for the preset time.)
3. Keyless Entry Operation
Press button #2 (lock/unlock), the parking lights will flash once and the doors will lock. Press button
#2 again, the parking lights will flash twice, the doors will unlock, and the parking lights will remain
on for one minute or until you turn the ignition on or press the brake.
4. Dome Light Supervision Option
The remote starter includes an optional output that can be used to illuminate the dome light when pressing
button #2 and unlocking your power door locks. The dome light will remain on for one minute or until
you turn the ignition
on or press the brake.
5. Trunk Pop Output
The remote car starter includes an optional output that can be used to do one of the following: open
the trunk (optional relay required), roll up the windows (optional module needed), close the sun roof
(optional module needed) etc. This output will pulse .75 seconds when pressed and released. In instances
where a continuous signal is needed such as sun roof and power windows, hold down Button #3 (trunk) as
long as the signal is needed to complete the task. The parking lights will remain on as long as this
button is being pressed.
6. Remote Car Finder (Armed Only)
When the unit is armed, press and release Button #4, the horn or siren will chirp three (3) times and
the parking lights will flash three (3) times.
7. Runtime Confirmation (Disarmed Only)
With the engine off, press and release Button #4 (stop). The parking lights will begin to flash, each
flash represents the programmed runtime. Example: 5 flashes = 25 minutes.
