6
7
8. Attach the YELLOW WITH BLACK STRIPE
wire to the large YELLOW WITH BLACK
STRIPE wire on the remote starter that is
connected to the starter/crank wire on the
ignition switch harness.
9. Attach the WHITE wire from the bypass
module to the large WHITE wire on the
remote starter that is connected to the
PINK ignition wire on the ignition switch
harness.
10. Put the key in the ignition and start the
vehicle.
11.
........
Wait until the L.E.D. light on the 791 goes
out. (See page 9 for LED placement.)
12. Turn off the vehicle, the system has learned
the resistor value.
13. The GREEN wire is not used.
NOTE: If the light does not illuminate on the 791
when you first plug it in, you need to erase the
memory. See page 10.
PASSLOCK I INSTALLATION
(GM only)
NOTE: Do not plug the WHITE loop connector
into the module unless your vehicle is equipped
with a transponder system.
PASSLOCK II INSTALLATION
(GM only)
1. Locate the wire harness coming from the
ignition switch. Inside, find .........three (3) small
gauge wires, a RED WITH WHITE STRIPE
wire, an ORANGE WITH BLACK STRIPE
wire or a BLACK wire, and a YELLOW wire
on trucks, vans and SUVs. On cars find a
BLACK wire, a YELLOW wire and a WHITE
wire.
2. Attach the YELLOW wire to the Passlock
YELLOW wire.
3. Attach the RED wire to a co12V
supply.
4. Connect the ORANGE wire to the ORANGE
WITH BLACK STRIPE wire or BLACK
Passlock ground wire.
5. Connect the BLUE wire to the center WHITE
wire on remote starter modules with an
external relay harness or the WHITE wire
labeled “ignition negative” or the YELLOW
wire and sometimes the YELLOW WITH
BLACK STRIPE wire marked “security
bypass out”.
6. Attach the WHITE wire to large WHITE
ignition wire on the remote starter connected
to the PINK wire on the ignition harness.
7. Attach the YELLOW WITH BLACK STRIPE
wire to the large YELLOW WITH BLACK
STRIPE wire on the remote starter that ...........
is connected to the starter/crank wire on .....the
ignition switch harness.
8. The PURPLE and the GREEN wires are not
used. Tape these wires up and do not use.
9. Put the key in the ignition switch and start
the vehicle.
1
2
3
To instrument
Panel Cluster
White or (Black/White)
Black
Yellow or (Black)
Orange
Y
ellow
These wires will be very
small in diameter.
Ignition
Switch
MODEL 791
