Bulldog Security 791P, Руководство по эксплуатации

Страница: 5 / 6

8 5
PASSLOCK I INSTALLATION
(GM only)
This FUEL SYSTEM shutdown anti-theft system is
based on a resistor built into the ignition switch. The
system is recognized by a security light on the
dashboard cluster.
1. Locate the harness coming from the ignition
switch inside, find the three small wires
YELLOW, BLACK and WHITE or (1)
BLACK WITH WHITE STRIPE wire and
(2) BLACK wires.
2. If your vehicle has the BLACK WITH
WHITE STRIPE wire and two (2) BLACK
wires, you will need to test the two (2)
BLACK wires WITH THE IGNITION KEY IN
THE ON OR RUN POSITION. Test both of
these wires, one will show ground and the
other will show positive.
3. Attach the YELLOW wire from the 791
bypass to the Passlock wire that shows a
positive.
4. Attach the ORANGE wire from the 791
bypass to the wire that shows a ground.
5. Attach the RED wire to a co12V
supply.
6. Attach the VIOLET wire to the bulb check
wire. A 22 ga. BLACK wire in slot “D” or
“E” coming from the ignition switch on the
left hand side of the steering column located
along with the heavy RED power wires in
the ignition switch harness. This wire will
test negative only during cranking.
7. Connect the BLUE wire to the center WHITE
wire on remote starter modules with an
external relay harness or the WHITE wire
labeled “ignition negative” or the YELLOW
wire and sometimes the YELLOW WITH
BLACK STRIPE wire marked “security
bypass out”.
10. .........Wait until the L.E.D. light on the 791 goes
out. (See page 9 for LED placement.)
11. Turn off the vehicle, the system has learned
the resistor value.
NOTE: If the light does not illuminate on the 791
when you first plug it in, you need to erase the
memory. See page 10.
PASSLOCK II INSTALLATION
(GM only)
NOTE: Do not plug the WHITE loop connector into
the module unless your vehicle is equipped with a
transponder system.
1
2
3
To instrument
Panel Cluster
Red/White or (White)
Orange/Black or (Black)
Yellow
Orange Y
ellow
These wires will be very
small in diameter.
Ignition
Switch
MODEL 791
TRANSPONDER INSTALLATION
Ford, Chrysler, all imports and some GMs
1. You must have a spare transponder key
that will start the vehicle. You will need
to insert this spare key inside the 791
module.
2. The wiring loop needs to be positioned
around the ignition switch. Place the
transponder loop around the ignition switch
and as close to the key hole as possible.
3. Connect the RED wire from the module to
a co12v supply.
4. Connect the BLUE wire to the center WHITE
wire on remote starter modules with an
external relay harness or the WHITE wire