1. Insert the muffler end of the CH1000 cooling vest
connector hose well into the air entry sleeve of the vest
leaving 2” of the connector hose exposed (Figure 1).
2. Install the small nylon clamp over the air entry sleeve
and cooling vest connector hose. Engage the clamp
locks and squeeze until tight (Figure 2).
heat shield Instructions
assembly
The heat shield is designed to work with the standard nylon
belt (part # 4612) supplied with the climate control devices,
or the 36501 vinyl belt which may be ordered separately.
1. Determine whether the climate control device will be
worn vertically or horizontally on the waist.
2. If the device will be worn in the horizontal position, align
the tube on the heat shield as shown in Figure 3. If the
tube will be worn in the vertical position, align the tube
on the heat shield as shown in Figure 4.
3. Lace the belt supplied with your climate control device
through both the heat shield slots and the climate control
belt bracket slots.
4. Use plastic zip tie to secure the climate control unit to
the heat shield.
assembling the cooling Vest
Back of vest
Figure 1
Figure 2
Figure 3
Figure 4
