Bull R425-E2, Инструкция по установке и эксплуатации

Страница: 67 / 156

Chapter 5: Advanced Serverboard Setup
5-33
I
2
C for PCI/PCI-E Slots
Jumper Settings
Jumper Setting Definition
Closed Enabled
Open Disabled (default)
I
2
C Bus to PCI-Exp. Slots
Jumpers JI
2
C1 and JI
2
C2 allow you to connect
the System Management Bus (I
2
C) to the PCI-
Express slots. These two jumpers must be set
at the same time. The default setting is Open to
disable the connections. See the table on the right
for jumper settings.
Compact Flash Enable
A Compact Flash Jumper is located at JIDE1. To
use a Compact Flash Card on this motherboard,
you will need to close Pins 1~2 on this jumper to
enable it. For the Compact Flash Card to work
properly, please connect the Compact Flash Card
power cable to JWF1 first. Refer to the board
layout below for the location.
Compact Flash Card Enable
Jumper Settings
Jumper Definition
Open Disabled
Closed Enabled
A: Ji²C1
B: JI²C2
C: Compact Flash
Enable