Bull R425-E2, Инструкция по установке и эксплуатации

Страница: 116 / 156

7-16
N
ovaS
c
ale R425-E2 Installation and User's Guide
use 3F8 as its I/O port address and IRQ 4 for the interrupt address. The options
for Serial Port1 are Disabled,
3F8/IRQ4 , 3E8/IRQ4, 2E8/IRQ3. The options for
Serial Port2 are Disabled, 2F8/IRQ3 , 3E8/IRQ4, and 2E8/IRQ3.

Remote Access Configuration
Remote Access
This allows the user to enable the Remote Access feature. The options are
Disabled and Enabled. If Remote Access is set to Enabled, the following items
will display:
Serial Port Number
This feature allows the user decide which serial port to be used for Console
Redirection. The options are COM 1 and
COM 2 .
Serial Port Mode
This feature allows the user to set the serial port mode for Console Redirection.
The options are
115200 8, n 1 ; 57600 8, n, 1; 38400 8, n, 1; 19200 8, n, 1;
and 9600 8, n, 1.
Flow Control
This feature allows the user to set the flow control for Console Redirection.
The options are None , Hardware, and Software.
Redirection After BIOS POST
Select Disabled to turn off Console Redirection after Power-On Self-Test
(POST). Select Always to keep Console Redirection active all the time after
POST. (Note: This setting may not be supported by some operating systems.)
Select Boot Loader to keep Console Redirection active during POST and Boot
Loader. The options are Disabled, Boot Loader, and
Always .
Terminal Type
This feature allows the user to select the target terminal type for Console
Redirection. The options are
ANSI , VT100, and VT-UTF8.
VT-UTF8 Combo Key Support
A terminal keyboard definition that provides a way to send commands from a
remote console. Available options are Enabled and Disabled.
Sredir Memory Display Delay
This feature defines the length of time in seconds to display memory information.
The options are No Delay , Delay 1 Sec, Delay 2 Sec, and Delay 4 Sec.