Bull escalata t430, Руководство по установке, Страница: 138 / 164

6-34
Setup Guide
Hot Swapping under RAID Configuration
Warning: Before handling any device, be sure you know the rules described in Device
Configuration , on page 5-7.
If a hard disk drive under RAID configuration is faulty, this is automatically detected.
Perform the following steps to replace a faulty hard disk drive.
1. Open the device shutter by turning the device shutter key to the right.
2. Identify the faulty hard disk drive through the amber LED light on and steady.
3. Physically remove the hard disk drive according to the instructions described in Hard
Disk Drive Removal step 5 , on page 6-30.
4. Replace the hard disk drive with a new one according to the instructions described in
Adding a Hard Disk Drive to a Disk Cage step 7 , on page 6-24.
5. The rebuilding procedure of the data on the new hard disk drive starts automatically. The
amber LED blinks until any operation on it is concluded.
Note: This operation can take more or less time depending on the number of hard disk
drives configured in the RAID array and their capacity.
6. Check that the amber LED light is off; this means that the swapping procedure is
successfully completed and the RAID configuration is restored.
7. Close the device shutter by turning the device shutter key to the left and store it safely.