9
MODEL 60019 NATURAL GAS (NG) SAFETY GUIDELINES
Your Natural Gas (G20) grill is designed to
use natural gas ONLY
. The grill operates at a pressure of 4” water column (wc)
or 10 mbar set at the natural gas regulator attached at the back of the grill. Prior to installing gas supply lines, check with
your local gas utility or municipality regarding local gas pressure and for building code requirements and instructions or
consult a licensed and knowledgeable installer.
NATURAL GAS PLUMBING GUIDELINES:
1)
Install an “ON-OFF” shutoff valve for OUTDOOR gas supply source after gas line piping exits outside wall, or before gas
piping enters ground.
2)
Install an “ON-OFF” shutoff valve for INDOOR gas supply source to the branch fuel line in an accessible location near the
supply line.
3)
Do not use
Teflon ® tape or pipe sealant on any flare ends because you will not obtain a leak-free seal.
4)
Use
only
Pipe sealing compound or pipe thread tape of the type resistant to the action of natural gas to at least the first
three threads of all male pipe threads when making the connection.
5)
Disconnect your gas grill from fuel source when the gas supply is being tested at high pressures. This appliance and its
individual shutoff valve must be disconnected from the gas supply piping system during any pressure testing of that system
at pressures in excess of 1/2 psig or 37 mbar.
6)
Turn off your gas grill when the gas supply is being tested at low pressures. This appliance must be isolated from
the gas supply piping system by closing its individual valve.
Refer to the following instructions and illustrations for typical gas supply connections.
We strongly suggest professional installation and
hook-up of the Gas BBQ. All regulators must meet EN16129 standard.
IMPORTANT:
Before connecting grill to gas source, make sure BBQ Grill control knobs are in “OFF” position.
Be sure to follow instructions for connecting an appliance to a fixed fuel piping system specifying the use of a rigid pipe, semi-
rigid tubing, and/or a connector that complies with the Standard for Connectors for Outdoor Gas Appliances and Manufactured
Homes, ANSI Z21.75 For post-mounted outdoor cooking gas appliances, in-ground metallic posts shall be protected against
corrosion as warranted by soil conditions. A suitable coating of corrosion protection will retard the effects of corrosion and help
your Bull purchase last longer.
IMPORTANT:
Bull Outdoor Products does not recommend the use of any quick
connect fittings or lines to the unit. Use of
these types of fittings or lines could cause low gas flow and greatly reduce the performance of the unit.
IMPORTANT CONNECTION STEPS:
1)
Do not use Teflon tape or pipe sealant on
any flare ends because you will not obtain a
leak free seal.
2)
Remove plastic cap from regulator
installed on grill.
3)
Attach stainless steel flex line 3/8 flare
female end to the regulator and the
other end to a nipple to allow
connection to a shut-off valve to the
gas supply.