5
6
Install your Faucet.
Install your RO System.
1. Attach the water source to the
RED
line of the RO system using the installed connector/adapter.
2. Direct the
BLUE
line from the Omnipure Inline Carbon Block to Mur-lok Tee and then to the Storage Tank and Air Gap Faucet.
3. Guide the
BLACK
line from the RO unit to the Waste Water (
BLACK)
Input of the Air Gap Faucet.
4. Guide the Waste Water (
BLACK
) line from the Air Gap Faucet to a drain.
RED
Tubing - intake from home water line
BLACK
Tubing - waste water
BLUE
Tubing
- output of purified water suitable for use in your reef tank.
Push connect fittings are connected by firmly pushing one end of
the tube into the fitting.
Remove tube by holding the round retention ring tightly against the
fitting and pull the tube.
The Air Gap Faucet requires a 7/8” hole in your counter top or sink bowl. If your sink has a sprayer it is possible that you may be able to remove it
and mount the faucet in the same hole. If you need to drill a hole make sure to check for any obstructions underneath the sink and to use the proper
tools for the material you are drilling. You will need enough room under the faucet to connect the waste water lines as well as the drinking water line.
Consult the instructions for the Air Gap Faucet on the faucet box for specific instructions about installing the faucet and connecting the product water
line (
blue
line).
• Connect the 1/4” waste water (
black
line) from the RO unit to the 1/4” barb fitting on the faucet.
• Use the included 3/8” black tubing to connect the 3/8” barb on the faucet to the drain saddle clamp.
It is normal for the air gap faucet to make a hissing or gurgling sound when the RO unit is running. This is not a malfunction but rather an indication
of the proper operation of the valve. The faucet is designed to break a siphon at the highest point in the event of a sewer backup; this prevents
contamination of your drinking water system.
7
Install your Storage Tank
1
2
4
3
Step 1:
1. Locate the
BLUE
line coming from the main RO unit.
2. Cut tube and insert TEE union into the newly cut ends.
Step 2:
1. Screw
the RO tank valve onto the top of the pressurized storage tank.
2. Using a small piece of tubing, connect the RO tank valve to a TEE.
3. Connect the
BLUE
tubing that goes from the faucet to the same TEE.
Decide where you would like to place the pressurized storage tank, preferably in close proximity to the faucet. This install has two steps:
