Page | 9
Pool/Spa Modes
The control is equipped with two independent thermostats, one for pool temperature and one for spa temperature.
This is to allow the user to preset a temperature of their choice and switch between the two settings.
To change between pool and spa modes,
Press the SET button until the control reads P_S
Press either arrow key to switch from POL to SPA
Once the heating mode has been selected, it will be displayed for five seconds and then return to the actual
pool water temperature. The lights on the right side of the display indicate the selected mode.
ATTENTION!
There is a 3 minute time delay upon initiation of a heating cycle. This is to ensure that the critical
components do not fail due to short cycling of the heater.
Displaying the Temperature in °F or °C
Heater comes pre-set in
°F
mode. If desired in
°C
mode, please call factory for instructions
Keypad Lockout Feature
Locking
To lock the keypad press the SELECT button for 5 seconds and the display will show spacing for a two digit
code “_ _” at the right hand side. Press Up and Down buttons to enter the code starting from 00 to 99. Enter
the code according to the pre-set. The control is shipped with pre-set code of 20, and then press SELECT
button. Each time a button is pressed the control will show “LOC” for 3 seconds and then show water
temperature
Unlocking
To unlock the keypad press the SELECT button for 5 seconds and the display will show spacing for a two
digit code “_ _” at the right hand side. Enter the code and press the SELECT button. If the correct code is
entered then the control switches to show the water temperature. If the incorrect code is entered then the
control will flash “LOC” for 3 seconds and switch back to “_ _”. If nothing is entered for the next 5 seconds
then the control will switch to show water temperature and remain locked.
Setting the Code
With the power to the heater is off, press and hold the SELECT button while applying power. The control
will then show the spacing for two digits “_ _”. Enter the desired code and press SELECT to save it.