31
*3-Button Remotes (315 MHz)
If provided with your garage door opener, the large button is
factory programmed to operate it. Additional buttons on any
S
AFETY
S
IGNAL
™
3-Button
remote or compact remote
can be programmed to
operate other
S
AFETY
S
IGNAL
™
garage door
openers.
To Erase All Codes From Motor Unit Memory
To deactivate any unwanted remote, first erase all codes:
Press and hold the “learn” button on motor
unit until the learn indicator light goes out
(approximately 6 seconds). All previous codes
are now erased. Reprogram each remote or
keyless entry you wish to use.
1. Press and release the “learn” button on
the motor unit. The learn indicator light
will glow steadily for 30 seconds.
2. Within 30 seconds, press and hold the
button on the hand-held remote* that you
wish to operate your garage door.
3. Release the button when the motor unit
lights blink. It has learned the code. If
light bulbs are not installed, two clicks will
be heard.
To Add or Reprogram a Hand-held Remote Control
USING THE “LEARN” BUTTON
2
1
KG
PROGRAMMING
Your garage door opener has already been programmed at the factory to operate with your hand-held remote control. The door will
open and close when you press the large push button.
Below are instructions for programming your opener to operate with additional
S
AFETY
S
IGNAL™
315 MHz remote controls.
2
1
KG
NOTICE:
If this
S
AFETY
S
IGNAL™
garage door opener is operated with a non-rolling code transmitter, the technical measure in the
receiver of the garage door opener, which provides security against code-theft devices, will be circumvented. The owner of the
copyright in the garage door opener does not authorize the purchaser or supplier of the non-rolling code transmitter to circumvent that
technical measure.
1
2
3
1
2
