Buhnen HB 720 R/S, Перевод оригинального руководства по эксплуатации

Страница: 20 / 52

Safety instructions
20
2.2 Instructions for safe operation / Intended use
Guard against malfunctions and operating errors by always following these instructions
precisely:
• The device may only be operated by persons who have been trained, instructed and
authorised to do so. These persons must be familiar with and capable of working in
accordance with the operating instructions.
• Before starting any work, check the device for visible damage and ensure that it is only
operated in perfect condition. Immediately notify the person responsible in your compa-
ny of any defects found.
• The processing temperature of the hot melt adhesive must not be exceeded. You will
find this information in the technical data sheet of the adhesive. Excessive temperature
can lead to decomposition products which can affect the health of the operator and the
ability of the device to function.
• Protect the device from moisture and damp (protection against electric shock).
• In no circumstances may the maximum permitted operating pressure (6 bar) be
exceeded.
• Remove combustible or heat-sensitive objects from the area of the nozzle.
• Never operate the trigger (13) forcibly.
• Do not use outdoors.
• Unplug from the mains before performing any operation on the device (servicing,
cleaning) und sichern es gegen Wiedereinschalten und prüfen die Spannungsfreiheit.
The device must be powered only from sockets with a protective conductor.
Any extension cable used must have a protective conductor. Check that the protective
conductor is undamaged before use.
• Check the applicator for externally visible damage at least once per shift.
Do not continue to operate the device if the housing exhibits damage caused by im-
pact, breakage or severe wear.
• If you notice any damage to the device or leads, unplug from the mains immediately.
Have the device promptly checked over by an expert. It must not be used again until it
has been properly repaired (see section
7 on page 33
).
• Never use solvents, petrol, benzene, toluene, acetone, turpentine or other flammable/
highly flammable agents for cleaning.
Danger of explosion here!
• Observe the instruction leaflet for the hot-melt adhesive (protection against processing
errors).
GB
H2200XM_DE-EN_200720.indd 20 26.07.21 08:55