DeNOx
1 Introduction
1.1 Intended Use
The sample gas probe is intended for installation into gas analysis systems in commercial applications. Sample gas probes are
among the main components in a gas conditioning system.
The area of application for DeNOx probes particularly spans installation into DeNOx systems. The DeNOx probe allows for tar-
geted washing out of ammonia and its salts and, thus allowing for low maintenance operation of downstream sample gas con-
ditioning. Another area of application is washing out aerosols.
• Before installing the device, verify the listed technical data meet the application parameters.
• Further check if all contents are complete.
Please refer to the nameplate to identify your model. In addition to the job number it also contains the item number and model
designation.
When connecting, please note the specific values of the device, and the correct version when ordering spare parts.
1.2 Type plate
Example:
Sample Gas Probe DeNOx
2017 02230017 462225000L
230V 50 Hz
Read manual!
Manufacturer including address
Model designation
ID no., Item no.
Electrical supply
1.3 Contents
• 1 x Sample gas probe
• 1 x Flange gasket, screws and nuts
• Product documentation
• Connection- and mounting accessories (only optional)
1.4 Ordering Instructions
Item no.
Description
46 222 5000L
Gas Probe Denox 230 V, 50 Hz; Left-hand heated line connection
46 222 5000R
Gas Probe Denox; 230 V, 50 Hz Right-hand heated line connection
1.5 Product description
Probe
Description
DeNOx-MB
Probe with outlet filter, glass pearl receptacle, condensate pump and frost protection heating.
Accessories
Sample gas probes can – depending on order – be delivered with accessories factory installed. This accessory,
as well as separate accessories included, are listed as separate line items in the order.
21
Bühler Technologies GmbH
BX460035 ◦ 08/2017