Buell 2006 P3, Руководство по обслуживанию

Страница: 95 / 419

2006 Buell P3: Chassis 2-7
HOME
WHEELS 2.4
GENERAL
Good handling and maximum tire mileage are directly related
to the care of wheels and tires. Regularly inspect wheels and
tires for damage and wear. If handling problems occur, refer
to
Table 2-8.
Keep tires inflated to the recommended air pressure. Always
balance the wheel after replacing a tire.
1 1
WARNING
1
WARNING
Do not inflate tire beyond maximum pressure as speci-
fied on sidewall. Over inflated tires can blow out, which
could result in death or serious injury. (00027a)
TROUBLESHOOTING
See Figure 2-3. Check tire inflation pressure at least once
each week. At the same time, inspect tire tread for punctures,
cuts, breaks and other damage. Repeat the inspection before
long trips.
Figure 2-3. Checking Tire Inflation Pressure
a0198x2x
Table 2-8. Wheel Service
CHECK FOR REMEDY
Loose axle nuts. Apply LOCTITE 243 (Blue) and tighten front axle nut (metric) to 38-42 ft-lbs
(52-57 Nm).
Tighten rear axle nut (metric) to 48-52 ft-lbs (65-71 Nm).
Excessive side-play or radial (up-and-down)
play in wheel hubs. Replace wheel hub bearings.
Alignment of rear wheel in frame or with
front wheel. Repair swingarm as described under 2.19 SWINGARM .
Rims and tires out-of-true sideways; should
not be more than 0.080 in. (2.03 mm). Replace rims. See 2.9 TIRES .
Rims and tires out-of-round or eccentric
with hub; should not be more than 0.090 in.
(2.29 mm). Replace rims. See 2.9 TIRES .
Irregular or peaked front tire wear. Replace as described under 2.5 FRONT WHEEL or 2.9 TIRES .
Correct tire inflation. Inflate tires to correct pressure. See 2.2 TIRE SPECIFICATIONS .
Correct tire and wheel balance. Static balance may be satisfactory if dynamic balancing facilities are not
available. However, dynamic balancing is strongly recommended.
Steering head bearings. Correct adjustment and replace pitted or worn bearings. See 2.18 FORK
STEM AND BRACKET ASSEMBLY .
Damper tubes. Check for leaks. See 2.17 FRONT FORK .
Shock absorber. Check damping action and mounts. See 2.15 REAR SHOCK ABSORBER .
Swingarm bearings. Check for looseness. See 2.19 SWINGARM .