Buell 2006 P3, Руководство по обслуживанию

Страница: 339 / 419

6-38 2006 Buell P3: Drive/Transmission
HOME
SHIFTER PAWL ADJUSTMENT 6.13
ADJUSTMENT
1. See Figure 6-54. Lift pawl over drum pins and place
shifter shaft assembly on studs at transmission case.
Loosely install a washer and locknut on each stud.
2. Install detent plate.
a. Place detent plate (9) over drum pins.
b. Rotate plate until blind holes in plate align with pins
in end of shifter fork drum.
c. Install new retaining ring (10) using SHIFT DRUM
RETAINING RING INSTALLER (Part No. HD-
39151).
3. Verify that retaining ring is fully engaged with drum
groove.
4. Attach loop of spring (11) over and into groove in pin (6).
5. See Figure 6-55. Align shifter shaft.
a. Place transmission in third gear.
b. Place a No. 32 drill bit (0.116 in. dia.) through hole in
detent plate (4), and between pawl (2) and drive pin
at end of shifter drum shaft.
c. Push down top of crank (3) to remove all clearance
between pawl and drill bit; this will correctly align
pawl to shift drum pins (do not push down with too
great a force, as this might cause the shifter drum to
rotate).
d. With bit in place, tighten shifter shaft assembly bot-
tom locknut (1) first to 90-110 in-lbs (10-12 Nm).
Then, tighten shifter shaft assembly top locknut (1)
to the same torque.
e. Remove drill bit .
Figure 6-54. Installing Shifter
1. Shifter shaft assembly
2. Locknut (2)
3. Washer (2)
4. Shifter pawl
5. Plate
6. Pin
7. Detent arm
8. Detent screw
9. Detent plate
10. Retaining ring
11. Spring
a0119x6x
3 2 1
6
7 8 9 10
11
4
5
Figure 6-55. Shifter Shaft Assembly Alignment
a0164x6x
1. Locknut (2)
2. Pawl
3. Crank
4. Detent plate
5. Shifter drum pin
6. Drill bit, No. 32 drill bit (0.116 in. dia. - 2.9mm)
5
4
2
2
3
1
6
6