BuckMaster FP-BR-10-ZC, Руководство пользователя

Страница: 10 / 39

Page 8
This list of specific instructions will help you make certain that
every installation operation is performed correctly. Complete
installation steps in sequence shown. STATE AND LOCAL
BUILDING CODES SHOULD BE CONSULTED IN ALL
CASES AS TO PARTICULAR REQUIREMENTS
CONCERNING INSTALLATION OF A FACTORY BUILT
FIREPLACES. Select location for fireplace by taking into
consideration factors previously outlined in “Choosing the
Location.” See page 5.
Framing the Firebox
The width of framed opening must be 26 1/8". The height of
framed opening must be 25 1/8". The entire fireplace can be
elevated above floor to achieve a raised hearth effect. This can be
done by adding a small platform to achieve desired height.
NOTE : The wiring for lower blower must be installed during
framing stage. The nailing flanges on both sides were designed to
allow installation of 1/2" wallboard or plywood flush with face of
fireplace.
When framing is inside, outside wall will be insulated. If framing
or chase is outside, thin insulation should be used in framing on
back, sides and top. The bottom should be insulated with a hard
insulating board. This will prevent cold from going into chase
through fireplace to living space.
Install Firebox
Install firebox into framed opening by placing it directly in front
of opening and sliding it into proper position.
Level Firebox
Check level of firebox on top edge of fireplace face. Shim if
necessary.
Secure Firebox
Secure fireplace to framing. The nailing flanges on firebox will
make securing firebox to frame quick and easy. Use appropriate
size nails or screws to secure firebox.
FIREPLACE CLEARANCES
The fireplace may be placed directly on a combustible floor, against
a combustible wall at marked clear-ances or on a raised wooden
platform.
If the fireplace is to be installed on a raised wooden platform,
platform must be a continuous level surface. The fireplace must be
secured in place so it cannot shift positions. The nailing flanges on
the sides of firebox make securing it to framing easy. They were
designed to allow installation of 1/2" wallboard or plywood flush
with face of fireplace.
Only header (see Figure 2) may rest on stand-offs on top of firebox.
When firebox is installed over carpeting, (vinyl) tile or any
combustible material other than wood flooring, it must be
installed on a metal or wood panel extending its full
width and
depth. Alternatively, carpeting, (vinyl) tile, etc. may be
removed beneath fireplace before installing.
COMBUSTIBLE MATERIALS MUST NOT BE
INSTALLED OVER OR TOUCH ANY BLACK
PAINTED SURFACE. DO NOT BLOCK HEAT
CIRCULATING AIR OUTLETS. DOING SO MAY
RESULT IN POTENTIAL FIRE HAZARDS.
1.
Sidewall Clearances: Clearances from side of fireplace
opening to any adjacent combustible wall should not be
less than 7".
2.
Ceiling Clearances: The ceiling height should
not be less than 42" from top of fireplace opening.
INSTALLING THE FIREBOX
26-1/8"
7" *
17-3/4"
1/2"
13-1/2"
25-1/8"
26-1/8"
FRONT
VIEW
SIDE
VIEW
TOP
VIEW
Figure 3
HEADER
FRAMING
13-1/2"
25-1/8"
* Note: Minimum 1/2" clearance
NOT required at this point