BuckMaster CR18, Руководство пользователя

Страница: 15 / 54

Page 13
CR30 LOG SET
(WITH DOUBLE BURNER DX24MV LOG BASE)
Open the cartons containing the Burner Base and the Log Set. Inside one of the cartons you will find the
Burner Base. The Log Set is boxed separately.
CR30: 1) Rear Log. 1) Middle Log. 2) Front Logs. 3A, 3B) Right Top Log. 4) Left Top Log 5).
There are (2) two brass round knobs to enhance your Log Set. The knobs are threaded in the bottom.
Position the knobs over the threaded studs of the front top andirons and tighten.
Remove the Front Log(s) Base Plate. The Base Plate sets just behind the front andirons with the two (2)
locator studs facing upward. Insure that the Base Plate is completely seated on to the log base. See dia-
gram bellow.
WARNING: POSITIONING OF THE LOGS IS VERY CRITICAL.
LOG PLACEMENT FOR CR30 LOG SET (SPLIT FRONT LOG) :
1) Align the two notches on the bottom rear of the Rear Log #1 over the rear log supports mounted to
the rear legs of the burner base.
2) Place the Middle Log #2 on the support between the front and rear burner sliding the log flush to the
back of the support. Center the log from side to side.
3) Next place Front Log #3A behind the front of the andirons (left side), resting on the locator stud,
which is located on the top of the front log(s) Base Plate. Repeat this step with Front Log #3B (right
side). The logs should meet and over lap in the center of the log base.
4) The Right Top Log #4 has (2) two holes provided to insure proper placement. Align the holes in the
log with the pins on the right hand side of the Middle Log #2, place the log gentility on to the pins.
5) To place the Left Top Log #5 use the (2) holes provided and the pins on the left side of the logs and
repeat the steps in #4.
DISCRIPTION DATE REV. BY APRVD
J.GLENN
2-2-00
11 GA. C.R.
UPPER HEAT SHIELD
M.BEASTON
N.T.S.
21 1/2" X 9 1/2"
22
PS220012
NEW RELEASE M.B. DATE
FRONT LOG(S)
BASE PLATE