BuckMaster 21 ELITE, Особенности Подготовка Установка Эксплуатация Техническое обслуживание Безопасность

Страница: 31 / 37

Page 29
MAINTENANCE
To replace Thermostat:
1. NOTE: Make sure stove is cool and unplug power cord to unit.
2. Remove access plate located at the rear of unit on the top right side of stove back by
removing four (4) screws holding plate. (See Figure 29).
3. Unplug wires to thermostat.
4. Remove the thermostat buy unscrewing two (2) screws holding the thermostat.
5. Replace thermostat with # listed in replacement parts list.
6. To reinstall thermostat reverse step 4.
7. Plug wires back onto thermostat.
8. Replace access plate located at the rear of unit and plug power cord in receptacle outlet.
To replace Motor from rear of unit:
1. NOTE: Make sure stove is cool and unplug power cord to unit.
2. To access motor, remove rear back by unscrewing the twelve (12) screws holding rear back to unit, lay a
side. (See Figure 29).
3. Remove two (2) screws holding motor cover and lay aside. (See Figure 30).
4. NOTE: Mark wires before unwiring motor.
5. Replace motor with new unit # MA5126715 .
7. If needed, See wiring diagram. (See Page 25, Figure 25).
6. To reinstall motor reverse steps 1-5. Plug power cord in receptacle outlet.
Figure 29.
ACCESS PLATE
STOVE BACK
REAR
BACK
POWER CORD
Figure 30.
MOTOR
COVER
FRONT LEFT
SIDE CABINET
MOTOR
CABINET
DOOR ’ S
THERMOSTAT
ACCESS PLATE
INNER BACK
OUTER BACK
REAR
BACK
. .
SCREW HOLES
SCREWS
HOLDING
REAR
BACK
RHEOSTAT