Buck 1011C, Руководство по эксплуатации

Страница: 30 / 48

- 30 -
APPENDIX 1
1011C PIN OUT:
DATA OUT
A
-DEW POINT INDICATION FLAG (5V = dew point)
B -COMMON
C -BALANCE
D -COMMON
E -PRESSURE
F -COMMON
G -TEMPERATURE (Dew Point)
H -COMMON
J -HEATER (NOT USED)
K -SHIELD
RS-232
2
- Rx
3 - Tx
5 - Ground
POWER
A
-+28 VDC
B -+28V Return
C -Chassis Ground (B and C are wired together on the cable, if supplied)
PRESSURE (to connect up an external pressure sensor)
A-
Heater Power, +28 VDC (optional)
B- Heater Return (optional)
D -Pr (blue wire from 4- 20 mA sensor)
E - Power, +16 VDC (red wire from 4-20 mA sensor)
J- Pressure – (do not use with 4-20 mA sensor)
K- Ground – (do not use with 4-20 mA sensor)
When using a 0-5 or 1-5 VDC sensor, you must use D,E,J and K or the sensor will not
work. Calibration instructions are available by request from Buck Research Instruments,
LLC.
Attach shield of cable to strain relief of connector using spade lug or ring terminal