btsr SMART MATRIX MTC, Руководство по эксплуатации

Страница: 49 / 82

Style Programming (MTC)
SMART MATRIX MTC 2 - 31
Select and set the each value in the
ADV window.
STOP TIME
:
This function allows you to choose the
type of signal that will be sent through the STOP
output in case of failure (
i.e. broken yarn ).
The possible choices are:
ƒ Continuous Signal ( CONT )
ƒ 2 seconds Pulse Signal ( P2s )
ƒ
10 seconds Pulse Signal ( P10s )
The electrical level of the signal ( either high or low )
depends on the configuration chosen for the STOP
OUTPUT function.
STOP OUTPUT : This function allows you to define
the operating mode of the STOP output in order to
meet the application needs. The signal may be
configured as Normally Open (
NO ) or Normally
Closed ( NC ).
STOP TYPE
:
This function allows you to choose the
type of signal that will be sent through the STOP
output when reaching the set Target.
The possible choices are:
ƒ Continuous signal ( CONT )
ƒ 4 Hz square wave form ( SQUARE )
The electrical level of the signal ( either high or low )
depends on the configuration chosen for the STOP
OUTPUT function. The SQUARE option can be
useful when the SMART terminal is connected to a
machine computer, as it gives the computer itself the
possibility to distinguish between a Target reached
stop and a failure stop.
BROKE DETECTION
:
This function allows you to
enable/disable the yarn broken/missing control
function performed by the sensor.
If the function is enabled (
ON ), then the sensor will
operate both as meter counter and as yarn breakage
control device. Otherwise, if the function is disabled
(
OFF ), the sensor will operate as meter counter
only.
COUNT SUSP .: when the target is reached or
there’s a broken yarn, the yarn runs still a little bit
because of inertia and this quantity is counted by the
sensor. If the function is
ON , the counter stops
immediately.
Details about STOP signal timing are
described in “STOP signal timing” paragraph on
section 3