btsr SMART CLEARER, Руководство по эксплуатации

Страница: 33 / 81

Operation
SMART CLEARER -3.21 -
MO-CTR - Configuring the system operation in either MONITOR mode or CONTROL
mode
SETUP CONFIG
MO-CTR
This function allows configuring the System Operation mode when a defect is
detected.
Monitor: Signals the error with a single red LED flash on the sensor, without
activating the Stop output. (*).
Control: Activates the Stop output and signals the error with a variable sequence
of red LED pulses.
1 - Flash
= NEP
2 Flashes = SLUB-
3 Flashes = SLUB+
3 - Flashes = SLUB
4 - Flashes = YARN-
5 - Flashes = YARN+
8 - Flashes = Yarn not running in the correct position or
dirtiness accumulation
Permanently lit = NOYARN
(*) In case of “yarn missing” (NOYARN) defect, the stop output is always
activated, independently of the current operating mode (either Monitor or
Control).
If you choose the Control mode, this is automatically assigned to all connected
sensors, while if you choose the Monitor mode you may assign this mode to either
all or just a given configurable range of sensors (for instance, on a machine having
40 sensors installed, you could choose to program the Monitor mode only on
sensors 7 to 20 – in this way, sensors 1 to 6 and 21 to 40 will automatically be
programmed in Control mode.
Once you have selected the MO-CTR function from CONFIG menu, press
to
have access to the function.
If necessary press
to select the desired option
(either CONTROL CONFIG
to activate the CONTROL function or MONITOR CONFIG to activate a
MONITOR function).
Press
to confirm.
Only if you choose the Monitor mode
XXX = First sensor of the section to be programmed in Monitor mode.
YYY = Last sensor of the section to be programmed in Monitor mode.
= moves the cursor from XXX field to YYY field
= increases the field pointed by the cursor
= decreases the field pointed by the cursor
Sensors before XXX and after YYY will automatically be programmed in Control
mode.