Technical Data and Installation
- 2.26 -
MULTIFEEDER
Instructions for Correct Yarn Threading
Thread the yarn into the upper ceramic bush
, lead it to the left of coil separation device
and run 3 turns
around the wheel
, passing above the separation device
, as shown on the figure.
Then lead the yarn over the loading cell
(tension sensor)
, and pull it out of the lower ceramic bush
,
keeping it tangent to the bush itself in such a way as to form an angle (
α
), as shown on the figure.
For a correct separation of yarn coils on coil separation device
, slightly tilt the separation device,
while the device is running, using the adjustment screw
.