btsr IS3W/TTS, Руководство по эксплуатации

Страница: 30 / 81

Operation
- 3.18 - SMART 200 TTS
DEVICE - Parameters setting for Initial installation
SETUP CONFIG DEVICE
This function allows the automatic numbering of the sensors connected to the
system. Once the function has been carried out the system will be able to identify
each one of the connected sensors, in univocal mode and with a progressive
number (from 1 to 200).
Press to activate the function.
XXX Indicates the number of sensors detected. Press to continue.
XXX indicates the number of sensors which shall be configured in the system. By
pressing
or
it is possible to either increase or decrease the value XXX
until the number of sensors actually connected to the system is reached.
At this point press to confirm.
This screen indicates that the phase of automatic sensor numbering is starting.
YYY shows the total amount of sensors to be numbered.
ZZZ shows the number of the first sensor
(and subsequently the next one) to be
numbered.
Check that the sensor being numbered has the green LED FLASHING which
indicates "Sensor ready to be numbered".
With a finger skim the “Touch Light” area of the sensor to which you wish to
assign the number shown by YYY and check that:
a)
The sensor LED changes from FLASHING green to red.
b) The number ZZZ is increased by 1 unit.
Once all the sensors have a unique number assigned, the DEVICE CONFIG
message re-appears.
Press once to return to the Setup/Programming menu, or press it twice to
return to the Main Menu.
A
1