24
RWA - Control Unit BCR
!
D
emounting
/ l
iability
/ D
isPosal
08
l
iability
We reserve the right to change or discontinue products at any time
without prior notice. Illustrations are subject to change. Although we take
every care to ensure accuracy, we cannot accept liability for the content
of this document.
d
emounting
and
dismantling
The Control Unit shall be stored only in locations protected from mois-
ture, severe contamination and temperature fluctuations (not beyond
30°C). The packaging shall not be removed until the control system is to
be installed. Disconnect the accumulators and store them separately after
the control device has already been in operation.
It is imperative that the following is observed for the storage of
the accumulators:
Before dismantling the Control Unit separate same com-
pletely from the mains!
In case the Control Unit is permanently decommissioned the statutory
provisions for the destruction, recycling and disposal shall be observed.
The control device contains plastic, metal, electrical components and ac-
cumulators. Replaced accumulators contain highly toxic pollutants and
may therefore only be disposed of at collection points prescribed by the
legislator.
Keep the storage time of lead-acid accumulators short,
because the accumulators discharge as time pas-
ses. At the latest after seven months in stora-
ge accumulators must be recharged. Use either a
suitable accumulator charger or connect the accumu-
lators to an EMB Control Unit and supply same with
mains voltage. In both cases the charging time
requires a minimum of 8 hours (depending on the
discharge).
d
isposal
According to the European Directive 2012/19 / EU on Waste Electrical
and Electronic Equipment (WEEE) and its transposition into national law,
obsolete electrical appliances must be collected separately and sent for
environmentally friendly recycling.
