Bticino 391780, Быстрый старт

Страница: 76 / 93

76
Click confirm button you can exit the setup. After move the cursor to back button to go to the previous interface.
- DELETE CRUISE: Delete a cruise.
Input cruise number in CRUISE NO and then move the cursor to DELETE cruise,
click confirm button to delete.
- CALL: Activate cruise.
Input touring number in touring NO and highlight CALL, click confirm button to activate touring.
- STOP: Terminate touring.
- BACK: Go back to previous menu.
- EXIT: Log out system menu.
Pattern
PATTERN NO: 001
PROGRAM START
PROGRAM STOP
RUN
STOP
BACK
EXIT
Pattern function can memory PTZ operation and camera focus zoom in and zoom out.
From the start position, dome begins auto movement repeatedly.
This series IP dome supports maximum 5 patterns and one pattern can max support 400 commands.
Move the cursor to PATTERN and click confirm button.
- PATTERN NO: Here is to set pattern number. The value ranges from 1 to 5.
Click left/right key to configure.
- PROGRAM START: Memorize pattern starting point.
An icon OK pops up in screen system begins memory pattern.
- PROGRAM STOP: Set pattern stop point. After all the movement, move the cursor to PROGRAM STOP
and then click confirm button. Now you have set one pattern.
System pops up an icon OK system has memories one pattern.
- RUN: Activate pattern.
Input pattern number, move the cursor to RUN and click confirm button, system begins running
pattern.
STOP: Stop current pattern. Input pattern number, move the cursor to STOP and click
confirm button. System stops current pattern.
BACK: Go back to previous menu.
EXIT: Log out system menu.
Note: The dwell time between two orders should be less than one minute, otherwise system will
set to default value as one minute.
After click PROGRAM STOP, do not click CALL button before icon “
•
” disappears completely.
Any manual operation during the pattern procedure will terminate current dome pattern operation.