3489GSM
Installer manual
29
2 INSTALLATION
For a correct installation, turn the device off and read the following instructions.
PWR
Power supply
RJ11
ANTENNA
SIM
USB
TEL1
TEL2
Communicator
1. Connect the GSM antenna found in the package to the SMA connector.
In case the interface is installed in combination with an alarm system station, install
the antenna at least 1,5 meters from the alarm system station itself.
2. Insert the SIM Card into the SIM holder. Be sure the SIM is inserted in the correct way being
careful of the SIM corner, so that the golden contacts are placed downwards.
3. Connect the Communicator to one of the TEL1 / TEL2 connector present on the back side. The
2 connectors are connected together so there is no difference between the two ports.
4. Connect the power supply and turn GSM/PSTN interface on using the switch.
2.1
FIRST POWER ON
After few seconds of the power on, at the end of the self test, you can see one of the following
situations.
LED
Regular situation
PIN required
Roaming / Virtual operator
Activity ON
ON
Blinking
GSM
Blinking / ON 1
OFF
Blinking
Status Blinking
ON
Blinking
1
GSM signal level.