Page | 10
Remote Display Connections
NOTICE!
The controller board should only be accessed when the power supply is disconnected.
Take special care when doing this because of the danger of electric shock.
Interface /
Function
Connector
marking
Notes
RS232
RXD
RXD line of the RS232 interface. The line should be connected to the weighing terminal TXD output
GND
GND line of the RS232 interface
0/20mA
digital
current loop
CL+
CL line of the current loop. The line should be connected to the weighing terminal TXD output
CL-
GND line of the current loop interface
RS485
RS422
A+
RS485 and RS422 interface non-inverting line, Weighing Terminals (+) output
B-
RS485 and RS422 interface inverting line, Weighing Terminals (-) output
GND
GND line of the RS485 and RS422 interfaces. Not recommended for use at risk of a significant
difference in ground potential of the display ground and weighing terminal ground
Ethernet
RJ45
RJ45 connector
110 ÷ 230
VAC power
supply
L
Phase conductor
N
Neutral conductor
PE
Protective conductor
Ethernet Settings to Transmit Weight Data
•
Default display IP is 192.168.1.11, default gateway to 192.168.1.1
•
Default weighing terminal IP set to 192.168.1.12. Data port 2102
. Select “Proto 53”,
or “Proto 54” protocol, then send the B-TEK String continuously. The indicator must
be set as server transmitting on port 2102, the remote is client.
•
The transmitting indicator IP address can be changed using the Devicer or Wagset
software.
