B
T
P
A
I
N
T
B
A
L
L
.
C
O
M
4
• Install the Rip-Clip
onto the marker’s
Picatinny rail (Fig.
3.4).
• Check the position
on the Picatinny rail
and make sure the
Rip-Clip is aligned
with the feed hole
on the side of the
marker (Fig. 3.5).
• Tighten up the
thumb nuts and
you’re ready to go.
Loader Installation
• You will notice that
the loader has an
alignment tab on
the left side.
• Locate the slot for
the tab within the Rip-Clip.
• Insert the loader into the slot and turn the loader Counter-clock-
wise until it is locked firmly into the Rip-Clip.
Activating the Rip-Clip
• Locate the power button on the rear of the Rip-Clip. Tap the
power button once to
turn the Rip-Clip on
(Fig. 3.6). The motor
will spin for a second
and the loader is now
ready to use.
• The green LED will
flash repeatedly
while the unit is on to
show it is ready. If the
LED flashing changes
to red, then the bat-
teries are low and
need to be replaced.
• To turn off the Rip-Clip, press and hold the power button until
the LED changes to Red. Release the button and the loader
will turn off. If the loader is left on, it will shut off after 1 hour
of inactivity.
Rip Drive
The Rip Drive is the thumbwheel located under the Rip-Clip and
has several uses.
Fig. 3.5
Fig. 3.6
Fig. 3.4
Rip_Clip_Manual_TM_Series.qxp 1/26/10 3:02 PM Page 4
www.WolfpackPaintballTeam.com
